
PRE-CUT WIDTHS
Sized for modern MTB and gravel rims - no trimming, no scissors, no guesswork.
HIGH-STICK ADHESIVE
Holds tight under pressure without lifting or slipping, even on wider rim beds.
RESETTABLE FIT
Strong but repositionable if needed - smooth install, zero stress.
Aussie-Trail Tested
Ridden hard and pressure-washed through Derby, Bright, and Narra.
Fitment & Specs - No Guesswork
Spec
Intended Use
Enduro / Trail
Internal Rim Width
30mm
Recommended Tyre Size
2.3” – 2.5”
Wheel Sizes
29” / 27.5”
Hub Spacing
Boost 110x15 (Front) / 148x12 (Rear)
Freehub Options
Shimano Microspline / SRAM XD / Shimano HG
Rotor Interface
Centerlock or 6-bolt (selectable)
Spokes
Sapim D-Light (32h front & rear)
588mm
Sapim D-Light (32h front & rear)
Tubeless Ready
Pre-taped & ready for setup
Max Rider Weight
XX kg (insert your limit if applicable)
Weight
XXXXg (full wheelset)
External Rim Width
30mm
GOT QUESTIONS? WE'VE GOT ANSWERS.
Match the internal width of your rim, then round up 1–2mm.
Example: 30mm internal = 30mm tape.
It’s pre-cut and labeled - no trimming needed. Just select the right width and roll.
One roll covers two 29” wheels with overlap - 10m per roll.
Nope. Just clean your rim bed, press the tape down firm, and smooth it by hand.
Yes - the adhesive is strong but forgiving. You can lift and reset during install without losing stick.
Yes. The adhesive and seal are designed to hold up under low PSI and insert compression.
Yes - but for best results, pair with Gnarly Sealant + High-Flow Valves.